How to Straighten Bent Miniatures

Flexible plastic miniatures (most of the figures we sell) can arrive with bent weapons, tails, wings, etc. Unlike metal, flexible plastic has a “memory,” so cold bending alone often isn't enough. Heat softens the plastic so you can reshape it, then cold water locks the new shape.

Prefer to watch? This short demo by Devs & Dice shows the hot-water / ice-water method on bent plastic miniatures.

What you need

  • A pot or heat-safe bowl of very hot water (near boiling is the usual hobby method; a full rolling boil is not required for thin parts)
  • A second bowl of ice water (ice cubes help)
  • Tongs, tweezers, or a small kitchen sieve (do not hold the figure in bare hands while it is hot)
  • A towel

Steps

  1. Heat water until it is very hot / near boiling. Keep the miniature off the bottom of the pot so it does not sit on hot metal.
  2. Using tongs or a sieve, dip the bent area (or the whole figure) into the hot water for several seconds to about a minute. Thin spears and swords soften faster; thicker parts need longer. Do not reshape it while it is still in the pot.
  3. Lift the figure out with tongs or a sieve and blot briefly if needed. The plastic will be soft and hot.
  4. Quickly reshape the bent part with tongs or very carefully with your fingers once it's cool enough to touch. Avoid clamping soft plastic hard with tongs or pliers, which can leave marks.
  5. While holding the new shape, immediately dunk the figure in ice water for 20–60 seconds so the plastic sets.
  6. Dry and check. Repeat if a stubborn bend remains; you can dip just the problem part on later passes.

Safety

  • Be careful and don't burn yourself. Adults should handle this for anyone under 18.
  • Never leave plastic sitting on the heating element or pot bottom.
  • Work over a stable surface; avoid splashing.

When not to use this method

  • Bones USA figures: this method is likely to damage these injected thermal plastic or 3D-printed figures, but luckily they rarely arrive bent.
  • Metal miniatures: do not boil them. Straighten unheated metal with fingers or pliers, carefully. If it's stubborn, warming the metal with a hair dryer can make it more pliable, but metal gets hot quickly so be careful!
  • Already painted figures: heat can crack or dull paint and varnish. Prefer mechanical fixes, or accept the bend; if you must try heat, expect paint damage and test on a scrap first.
  • Resin / brittle plastics: some resins soften differently or can warp badly. If you are unsure of the material, start with shorter dips and lower heat, or skip heat entirely.
  • Glue joints / multi-part builds: hot water can soften or weaken some glues.

Afterward

If you wash the figure before painting, use cool water after a heat-straighten, or wash before you reshape. Later high heat can make flexible plastic warp again.

This guide is general hobby advice for flexible plastic miniatures sold at Gnomish Bazaar and elsewhere. It is not a substitute for manufacturer care sheets when a brand publishes its own.